Gardlok

Low Battery Warning

THERE IS NO “POWER OVER-RIDE” OR “KEY OVER-RIDE” FOR THIS LOCK.  IT IS VERY IMPORTANT TO KNOW THE LOW BATTERY WARNING SIGNS!

  • Stage 1 – Codes will need to be entered twice to trigger lock followed by eight (8) rapid beeps. This will only occur for 20 openings.
  • Final Stage – Codes will need to be entered three (3) times before the lock will open. If the battery is not changed the lock will eventually stop working

To enter a New Master Code

The Master Code is always stored in key ‘1’ of the lock. All other nine combinations are stored in keys 2 to 0.  

  1. Press & hold the ‘0’ key until the lock beeps twice
  2. Enter existing Master Code (factory default is 111111) followed by  the ‘1’ button – the lock will beep twice.
  3. Enter a new 6-digit Master – the lock will beep twice.
  4. Re-enter the new Master code to confirm – a long beep will sound indicating a successful change.

To Add or Change a User Code

Each User Code is stored in one of the remaining nine keys (2 through 0).  

  1. Press & hold the ‘0’ key until the lock beeps twice.
  2. Enter Master Code – the lock will beep twice.
  3. Press the key to assigned to this user (2 through 0) – the lock will beep twice.
  4. Enter 6-digit User Code – the lock will beep twice.
  5. Re-enter 6-digit User Code – a long beep will sound indicating a successful add/change.

To Enable or Disable a User Code

  1. Press & hold the ‘0’ key until the lock beeps twice.
  2. Enter Master Code – the lock will beep twice.
  3. Press the key to assigned to the user you want to disable (2 through 0) – the lock will beep twice.
  4. Choose one of the following
    1. To Disable a User Code – Press and hold the ‘2’ button until the lock beeps twice indicating the Users Code is disabled.
    2. To re-enable a User Code – Press and hold the ‘4’ button until the lock beeps twice indicating the Users Code is enabled.